How do Anderson plug terminals and wires connect?

Anderson plug terminals and wires are connected as follows:

1. Prepare the Anderson plug terminal and cable respectively, and ensure that the cable length and terminal size are appropriate.
2. Use a wire stripper or a wire stripper to peel off the outer part of the wire to expose the inner wire.
3. Use a wire stripper or a wire stripper to peel off the end of the conductor again to expose a bare piece of conductor.
4. Insert the bare wire into the hole in the Anderson plug terminal, ensuring that the wire is inserted to the bottom without leaving a gap.
5. Clamp the crimping part of the Anderson plug terminal with crimping pliers and fix the wire in the plug terminal.
6. Finally check whether the connection is strong, you can gently pull the line and plug to ensure that there is no loosening or falling off between them.
   It should be noted that when connecting Anderson plug terminals and wires, be sure to ensure that the length of the wires and the size of the terminals are appropriate to avoid too long or too short to cause the connection is not strong. At the same time, it is also necessary to choose the appropriate tool to avoid damaging the wire or plug terminals.